Optical Transceiver SFP+ 8.5Gb/s 10KM 1310nm LC
กดเพื่อขยายขนาด |
|
Optical Transceiver SFP+ 8.5Gb/s 10KM 1310nm LC
OLSP3161L-CD10
RoHS Compliant 8.5Gb/s SFP+ 1310nm 10km Optical Transceiver
Part Number | Package Style | Data Rate | Reach | Wavelength No | Connector |
---|---|---|---|---|---|
OLSP3185L-CD10 | SFP+ | 8.5Gb/s | 10KM | 1310nm | LC |
PRODUCT FEATURES
DFB transmitter, PIN photo-detector
Duplex LC connector
Metal enclosure, for lower EMI
Class 1 Laser International Safety Standard IEC-60825 compliant
Up to 10km transmission distance
2-wire interface for management
Specification compliant with SFF-8472
Single 3.3V power supply
Very low EMI and excellent ESD protection
Case operating temperature range: 0°C to +70°C
APPLICATIONS
Compliance with Fiber Channel FC-PI-4 800-SM-LC-L
Compliant with 8G,4G and, 2G Fiber Channel
Complaint to SFP+ MSA
RoHS Compliant.
FUNCTIONAL DIAGRAM
ABSOLUTE MAXIMUM RATINGS
Note: Stress in excess of the maximum absolute ratings can cause permanent damage to the module
GERERAL OPERATING CHARACTERISTICS
ELECTRICAL INPUT/OUTPUT CHARACTERISTICS
Transmitter
Receiver
Note 1) TD+/- are internally AC coupled with 100Ω differential termination inside the module.
Note 2) Tx Fault and Rx LOS are open collector outputs, which should be pulled up with 4.7k to 10kΩ resistors on the host board. Pull up voltage between 2.0V and Vcc+0.3V.
Note 3) RD+/- outputs are internally AC coupled, and should be terminated with 100Ω (differential) at the user SERDES.
OPTICAL CHARACTERISTICS
Transmitter
Receiver
Note 1) Class 1 Laser Safety per FDA/CDRH and IEC-825-1 regulations.
Note 2) 20%~80%
Note 3) Measured with a PRBS 231-1 test pattern, @6.25Gb/s, BER<10-12
PIN DEFINITIONS AND FUNCTIONS
Note 1) The module ground pins shall be isolated from the module case.
Note 2) This pin is an open collector/drain output pin and shall be pulled up with
4.7K-10Kohms to Host_Vcc on the host board.
Note 3) This pin shall be pulled up with 4.7K-10Kohms to VccT in the module.
Note 4) This pin is an open collector/drain output pin and shall be pulled up with
4.7K-10Kohms to Host_Vcc on the host board. In FC designated as RX_LOS, inSONET
designated as LOS, and in Ethernet designated at Signal Detect.
TYPICAL INTERFACE CIRCUIT
Recommended power supply filter
Note: Inductors with DC resistance of less than 1Ω should be used in order to maintain the
required voltage at the SFP input pin with 3.3V supply voltage. When the recommended
supply filtering network is used, hot plugging of the SFP transceiver module will result in an
inrush current of no more than 30 mA greater than the steady state value
PACKAGE DIMENSION
ความคิดเห็น: คำแนะนำ: HTML จะไม่ถูกแปลง!
ความนิยม: แย่ ดี
ป้อนรหัสในกล่องข้างล่างนี้: